| Available Operating Frequencies |
|
150 MHz Band: Range from 135 to 185 MHz |
|
230 MHz Band: Range from 215 to 250 MHz |
|
250 MHz Band: Range from 235 to 265 MHz |
|
330 MHz Band: Range from 300 to 350 MHz |
|
450 MHz Band: Range from 430 to 480 MHz |
|
950 MHz Band: Range from 935 to 965 MHz |
 |
| RF Specifications |
|
Typical Max RF Output Power: |
|
Power @ 135-185 MHz: 30 W |
|
Power @ 215-250 MHz: 30 W |
|
Power @ 235-265 MHz: 30 W |
|
Power @ 300-315 MHz: 30 W |
|
Power @ 315-350 MHz: 30 W |
|
Power @ 430-480 MHz: 30 W |
|
Power @ 935-960 MHz: 20 W |
|
Power @ 960-965 MHz: 30 W |
|
Selection: Any two frequencies within selected band can be factory set with 5 and 6.25 kHz steps |
|
Deviation: Adjustable, ±20 kHz max |
|
Stability over Operating Temperature range: ± 0.0001% |
|
Agility and Accuracy: |
|
For frequencies <480 MHz divisible by 5 kHz or 6.25 kHz: ± 0.00004% |
|
For MOST frequencies <480 MHz NOT divisible by 5 kHz or 6.25 kHz: ± 0.00015% |
|
For frequencies >800 MHz divisible by 10 kHz or 12.5 kHz: ± 0.00004% |
|
For MOST frequencies >800 MHz NOT divisible by 10 kHz or 12.5 kHz: ± 0.00015% |
|
| Audio Specifications |
|
Modulation Control: Broadcast quality compressor/limiter built-in |
|
Audio Input Level: |
|
Mic In: -68 dB to -35 dB |
|
Line In: 0 to +10 dBm, 8-600 Ohms |
|
Mono Operation: |
|
Frequency Response: |
|
|
50 Hz to 3 kHz: ± 1.5 dB, 1.5 kHz Dev |
|
|
50 Hz to 7.5 kHz (Standard): ± 1.5 dB, 5 kHz Dev |
|
|
50 Hz to 10.5 kHz: ± 1.5 dB, 7.5 kHz Dev |
|
Signal To Noise: ≥ 53 dB, 5 kHz deviation, 75 µsec pre/de-emphasis |
|
Frequency Response: ±1.5 dB from 50 Hz to audio bandwidth, 75 µsec pre-emphasis |
|
Distortion: ≤ 2% from 50 Hz to audio bandwidth, 75 µsec pre-emphasis |
|
Spurious Emission: More than 60 dB below carrier |
|
Encoding: Sub-audible (27 Hz) tone encoder built in |
|
RF Output Impedance: 50 Ohm |
|
| Mechanical/Physical |
|
Audio Inputs: 4 balanced microphone (150 Ohm) inputs (XLR-3) with mixing controls, 1 input switchable to balanced line level at no. 4 input and D connector on rear |
|
Accessory Connector: 15-pin D connector for DC power, remote control, encode, line level input |
|
RF Connector: Type N female |
|
Dimensions (Unpacked): 3.5"H x 11.5"W x 14.3"D (8.9cm H x 29.2cm W x 36.8cm D) |
|
Weight (Unpacked): 8.25 lbs (3.74 Kg) |
|
| Environmental |
|
Operating Temperature: -10° C to +45° C |
|
Altitude: 10,000 ft (3048m) max |
|
Humidity: 95% maximum, non-condensing |
|
| Electrical |
|
Approx PA Current Reading (at max power output): 6.5 A to 7.5 A |
|
Power Requirements: |
|
AC: 110-120 VAC or 220-240 VAC (manually switched internally on power supply), 50/60 Hz |
|
External DC: 12-15 V to 15-30 V |
|
Power Consumption: 300 W Max (150 W Typical) |
|
Heat Dissipation: 300 W Max |
|
Fuse: 2.5 A Slo-Blo for 115 VAC operation, 1.25 A Slo-Blo for 230 VAC operation |
|
